Synco WAir G2-A1 radio system

The built-in DSP chip in the Synco WAir G2 wireless microphone system directly optimizes signals from transmitter to receiver. The technology allows real-time audio processing thanks to the DSP digital signal processor. Which is first used in small wireless microphone systems. The analog signals collected by the transmitter are converted to digital form for re-calibration of the sound, after which the processed sound is immediately delivered to the receiver. This post-processing takes place instantly and the sound quality will be much higher.

The transmitter and receiver are equipped with TFT color displays, which boast fast response, high brightness and contrast, excellent readability at different light intensities. The display shows information about the current recording mode, battery status, and sound level.

There is a mute switch on the body of the transmitter, which allows you to turn off the microphone for a while at the right time, for example, when adjusting the sound or talking that should not fall into the sequence. You just need to press the "MUTE" button and not turn off the device completely.

There is a miniJack 3.5mm connector on the transmitter body for the ability to connect a wired lavalier or microphone to the gun. Connecting external microphones significantly expands the possibilities of using the radio system and does not limit yourself only to the built-in microphone of the transmitter if it is not suitable for a specific task.

SYNCO G2 A1 has a low pass filter to remove noise below 180 Hz. This frequency is usually found in wind noise, the sound of an air conditioner, or traffic. The wireless microphone receiver has a gain control button in 8dB increments for easy and efficient adjustment and enhancement of signal levels.