Synco WAir G2-A2 radio system

Synco G2-A2 includes two transmitters with built-in microphones and a two-channel receiver for recording two persons simultaneously on a camera or camcorder. There are additional output modes, mono or stereo, combined with a soundtrack or a separate soundtrack to choose from.

The built-in DSP chip in the Synco WAir G2 wireless microphone system directly optimizes signals from transmitter to receiver. The technology allows real-time audio processing thanks to the DSP digital signal processor. Which is first used in small wireless microphone systems. The analog signals collected by the transmitter are converted to digital form for re-calibration of the sound, after which the processed sound is immediately delivered to the receiver. This post-processing takes place instantly and the sound quality will be much higher.

The transmitter and receiver are equipped with TFT color displays that boast fast response, high brightness and contrast, excellent readability at different light intensities. The display shows information about the current recording mode, battery status, and sound level.

There is a mute switch on the transmitter housing, which allows you to turn off the microphone for a while at the right time, for example, when sound is being tuned or a conversation that should not get into the audio sequence. You just need to press the "MUTE" button and not turn off the device completely.

There is also a sound gain control button on the transmitter body, thanks to this, you can adjust the level depending on the strength of the sound source, which allows you to remove unnecessary peaks and distortions, thereby ultimately getting the highest quality audio track. The SYNCO G2 A2 is also equipped with a low-pass filter to remove noise below 180 Hz. This frequency is usually found in wind noise, the sound of an air conditioner, or traffic. All these technologies guarantee high sound quality!